- Mapdl.anmres(delay='', min_='', max_='', inc='', autocntrky='', freq='', ext='', **kwargs)#
Performs animation of results over multiple results files in an
APDL Command: ANMRES explicit dynamic structural analysis or fluid flow analysis with remeshing.
Time delay during animation (default = 0.5 seconds).
Minimum results file number to animate. Default = 1 (for Jobname.RS01).
Maximum results file number to animate. Defaults to the highest numbered results file, Jobname.RSnn.
Increment between results file numbers. Default = 1.
Automatic contour scaling option.
0 - No auto-scaling (default).
1 - Auto-scaling on.
Results frequency key.
0 or 1 - Animate every results set in each Jobname.EXT file (default).
2 - Animate every other results set in each Jobname.EXT file.
n - Animate every nth results set in each Jobname.EXT file.
Extension of result files
‘rfl’ - Animate Jobname.rflnn
‘rs’ - Animate Jobname.rsnn. Default = ‘rs’.
ANMRES invokes an ANSYS macro that performs animation across multiple results files (Jobname.EXT, Jobname.EXT, etc.) produced by an explicit dynamic structural analysis or fluid flow analysis with remeshing. Multiple results files typically occur when adaptive meshing is used in an explicit dynamic structural analysis or fluid flow analysis with remeshing. Each results file must have more than one set of results. ANMRES cannot be used for multiple results files that are caused by file splitting.
ANMRES animates results from files having the currently specified jobname (Jobname.EXT - Jobname.EXT). To change the current jobname, use the /FILNAME command. The animation is based on the last plot command (e.g., PLDISP).
Distributed ANSYS Restriction: This command is not supported in Distributed ANSYS.