- Mapdl.edopt(option='', value='', **kwargs)#
Specifies the type of output for an explicit dynamics analysis.
APDL Command: EDOPT
Label identifying the option to be performed:
ADD - Define an output type specification (default).
DELE - Delete an output type specification.
LIST - List the current output type specification.
Label identifying the type of output that the LS-DYNA solver should produce:
- ANSYS - Write results files for the ANSYS postprocessors
(default). The files that will be written are Jobname.RST and Jobname.HIS (see “Notes” below).
- LSDYNA - Write results files for the LS-DYNA postprocessor
(LS-POST). The files that will be written are D3PLOT, and files specified by EDOUT and EDHIST (see “Notes” below).
BOTH - Write results files for both ANSYS and LS-DYNA postprocessors.
By default, LS-DYNA will write the ANSYS results file Jobname.RST (see the EDRST command.) If Jobname.HIS is desired, you must also issue EDHIST.
Value = LSDYNA or BOTH will cause LS-DYNA to write results files for the LS-POST postprocessor. The D3PLOT file is always written for these two options. If other LS-POST files are desired, you must issue the appropriate EDHIST and EDOUT commands.
This command is also valid in PREP7.
Distributed ANSYS Restriction: This command is not supported in Distributed ANSYS.