- Mapdl.edwrite(option='', fname='', ext='', **kwargs)#
Writes explicit dynamics input to an LS-DYNA input file.
APDL Command: EDWRITE
Sets a flag in the LS-DYNA input file (Fname.Ext) to produce desired output.
- ANSYS - Set a flag to write results files for the ANSYS
postprocessors (default). The files that will be written are Jobname.RST and Jobname.HIS (see Notes below).
- LSDYNA - Set a flag to write results files for the LS-DYNA
postprocessor (LS-POST). The files that will be written are D3PLOT, and files specified by EDOUT and EDHIST (see Notes below).
BOTH - Set a flag to write results files for both ANSYS and LS-DYNA postprocessors.
File name and directory path (80 characters maximum, including directory; this limit is due to an LS-DYNA program limitation). If you do not specify a directory path, it will default to your working directory. The file name defaults to Jobname. Previous data on this file, if any, are overwritten.
Filename extension (eight-character maximum).
This command writes an LS-DYNA input file for the LS-DYNA solver. EDWRITE is only valid if explicit dynamic elements have been specified. This command is not necessary if the LS-DYNA solver is invoked from within ANSYS, in which case Jobname.K (or Jobname.R) is written automatically when the solution is initiated. (If LS-DYNA is invoked from within ANSYS, use EDOPT to specify desired output.)
If the analysis is a small restart (EDSTART,2), the file that is written will have the name Jobname.R (by default) and will only contain changes from the original analysis.
If the analysis is a full restart (EDSTART,3), the file that is written will have the name Jobname_nn.K (by default) and will contain all the information from the database. In a full restart, the jobname is changed to Jobname_nn (nn = 01 initially, and is incremented for each subsequent full restart.)
A command is included in the LS-DYNA input file to instruct the LS-DYNA solver to write the results files indicated by Option. By default, LS- DYNA will write the ANSYS results file Jobname.RST (see the EDRST command). If Jobname.HIS is desired, you must also issue EDHIST.
Option = LSDYNA or BOTH will cause LS-DYNA to write results files for the LS-POST postprocessor. The D3PLOT file is always written for these two options. If other LS-POST files are desired, you must issue the appropriate EDHIST and EDOUT commands.
This command is also valid in PREP7.
Distributed ANSYS Restriction: This command is not supported in Distributed ANSYS.