ansys.mapdl.core.Mapdl.bfunif

Mapdl.bfunif(lab='', value='', **kwargs)

Assigns a uniform body-force load to all nodes.

Mechanical APDL Command: BFUNIF

Command default:

Set TEMP to the reference temperature ( tref but not mp,REFT), and FLUE and HGEN to zero.

Parameters:

labstr

Valid body load label. If ALL, use all appropriate labels.

This command contains some tables and extra information which can be inspected in the original documentation pointed above.

valuestr

Uniform value associated with Lab item, or table name when specifying tabular boundary conditions. To specify a table, enclose the table name in percent signs (%), for example, bfunif, Lab,``tabname``.

Notes

In a transient or nonlinear thermal analysis, the uniform temperature is used during the first iteration of a solution as follows: (a) as the starting nodal temperature except where temperatures are explicitly specified ( d, dk ), and (b) to evaluate temperature-dependent material properties. In a structural analysis, the uniform temperature is used as the default temperature for thermal strain calculations and material property evaluation except where body load temperatures are specified ( bf, bfe, bfk, ldread ). In other scalar field analyses, the uniform temperature is used for material property evaluation.

An alternate command, tunif, may be used to set the uniform temperature instead of bfunif,TEMP. Since tunif (or bfunif,TEMP) is step-applied in the first iteration, you should use bf, ALL, TEMP, Value to ramp on a uniform temperature load.

You can specify a table name only when using temperature (TEMP), heat generation rate (HGEN), and diffusing substance generation rate (DGEN) body load labels. When using TEMP, you can define a one- dimensional table that varies with respect to time (TIME) only. When defining this table, enter TIME as the primary variable. No other primary variables are valid.

In a mode-superposition harmonic or transient analysis, you must apply the load in the modal portion of the analysis. Mechanical APDL calculates a load vector and writes it to the MODE file, which you can apply via the lvscale command.

This command is also valid in PREP7.