zoom#

Mapdl.zoom(wn='', lab='', x1='', y1='', x2='', y2='', **kwargs)#

Zooms a region of a display window.

APDL Command: /ZOOM

Parameters:
wn

Window number to which command applies (defaults to 1).

lab

Label to define the desired type of zoom:

OFF - Turns zoom off (refits image of entire model to the window).

BACK - Goes back to previous zoom setting (five successive back ups, maximum).

SCRN - Interprets X1,Y1 as the screen coordinates of the center of a square zoom

region; X2,Y2 as the screen coordinates of a point on one side of that square.

RECT - Interprets X1,Y1 and X2,Y2 as the screen coordinates of two opposite corners of

a rectangular zoom region.

Notes

Zooms (centers and magnifies) the specified region of a display window. /ZOOM will operate on a display that has been formed by an explicit graphics action command (APLOT, EPLOT, etc.). /ZOOM has no effect on an “immediate” graphics display. When /ZOOM is executed, the display is automatically replotted such that the specified zoom region is centered and sized to fill the window.

Auto resizing is disabled when you issue the /ZOOM command. To restore auto resizing, issue the /AUTO command, or select FIT from the Pan, Zoom, Rotate box.

This command is valid in any processor.