rappnd#

Mapdl.rappnd(lstep='', time='', **kwargs)#

Appends results data from the database to the results file.

APDL Command: RAPPND

Parameters:
lstep

Load step number to be assigned to the results data set. If it is the same as an existing load step number on the results file, the appended load step will be inaccessible. Defaults to 1.

time

Time value to be assigned to the results data set. Defaults to 0.0. A time value greater than the last load step should be used.

Notes

This command is typically used to append the results from a load case combination to the results file. See the LCWRITE command to create a separate load case file. Only summable and constant data are written to the results file by default; non-summable data are not written unless requested (LCSUM command). RAPPND should not be used to append results from a harmonic analysis.

Distributed ANSYS Restriction: This command is not supported in Distributed ANSYS.