cmsopt#

Mapdl.cmsopt(cmsmeth='', nmode='', freqb='', freqe='', fbddef='', fbdval='', iokey='', **kwargs)#

Specifies component mode synthesis (CMS) analysis options.

APDL Command: CMSOPT

Parameters:
cmsmeth

The component mode synthesis method to use. This value is required.

FIX

Fixed-interface method.

FREE

Free-interface method.

RFFB

Residual-flexible free-interface method.

nmode

The number of normal modes extracted and used in the superelement generation. This value is required; the minimum is 1.

freqb

Beginning, or lower end, of frequency range of interest. This value is optional.

freqe

Ending, or upper end, of frequency range of interest. This value is optional.

fbddef

In a free-interface (CMSMETH = FREE) or residual-flexible free- interface (CMSMETH = RFFB) CMS analysis, the method to use for defining free body modes:

FNUM

The number (FDBVAL) of rigid body modes in the calculation.

FTOL

Employ a specified tolerance (FDBVAL) to determine rigid body modes in the calculation.

FAUTO

Automatically determine rigid body modes in the calculation. This method is the default.

RIGID

If no rigid body modes exist, define your own via the RIGID command.

fbdval

In a free-interface CMS analysis (CMSMETH = FREE), the number of rigid body modes if FBDDEF = fnum (where the value is an integer from 0 through 6), or the tolerance to employ if FBDDEF = ftol (where the value is a positive real number representing rad/sec). This value is required only when FBDDEF = fnum or FBDDEF = ftol; otherwise, any specified value is ignored.

iokey

Output key to control writing of the transformation matrix to the .TCMS file (FIX or FREE methods) or body properties to the .EXB file (FIX method).

TCMS

Write the transformation matrix of the nodal component defined by the OUTPR command to a .TCMS file. Refer to TCMS File Format in the Programmer’s Reference for more information on the this file.

EXB

Write a body property input file (.EXB file) containing the condensed substructure matrices and other body properties for use with AVL EXCITE. Refer to ANSYS Interface to AVL EXCITE in the Substructuring Analysis Guide for more information.

Notes

CMS employs the Block Lanczos eigensolution method in the generation pass.

CMS supports damping matrix reduction when a damping matrix exists. Set the matrix generation key to 3 (SEOPT,Sename,SEMATR) to generate and then reduce stiffness, mass, and damping matrices.

CMS does not support the SEOPT,,,,,RESOLVE command. Instead, ANSYS sets the expansion method for the expansion pass (EXPMTH) to BACKSUB.

For more information about performing a CMS analysis, see Component Mode Synthesis in the Substructuring Analysis Guide.

If IOKEY = TCMS is used to output the transformation matrix, then only ITEM = NSOL is valid in the OUTPR command. In the interactive sessions, the transformation matrix will not be output if the model has more than 10 elements.

This command is also valid in /PREP7.