cint#
- Mapdl.cint(action='', par1='', par2='', par3='', par4='', par5='', par6='', par7='', **kwargs)#
Defines parameters associated with fracture parameter calculations
APDL Command: CINT
- Parameters:
- action
Specifies action for defining or manipulating initial crack data:
- NEW
Initiate a new calculation and assign an ID.
- CTNC
Define the crack tip node component.
- CENC
Define the crack extension node component, the crack tip node, and the crack extension direction.
- TYPE
Define the type of calculation to perform.
- DELE
Delete the
CINT
object associated with the specified ID.- NCON
Define the number of contours to be calculated in the contour-integral calculation.
- SYMM
Indicate whether the crack is on a symmetrical line or plane.
- NORM
Define the crack plane normal.
- UMM
Activate or deactivate the unstructured mesh method.
- EDIR
Crack-assist extension direction.
- PLOT
Plots crack front and crack tip coordinate system.
- CXFE
Define the crack tip element or crack front element set. Valid for XFEM-based crack-growth analysis only.
- RADIUS
Define the radius at which the given value is to be evaluated. Valid for XFEM-based crack-growth analysis only.
- RSWEEP
Define the minimum and maximum sweep angle from existing crack direction. Valid for XFEM-based crack-growth analysis only.