edasmp#
- Mapdl.edasmp(option='', asmid='', part1='', part2='', part3='', part4='', part5='', part6='', part7='', part8='', part9='', part10='', part11='', part12='', part13='', part14='', part15='', part16='', **kwargs)#
Creates a part assembly to be used in an explicit dynamic analysis.
APDL Command: EDASMP
- Parameters:
- option
Label identifying the part assembly option to be performed.
ADD - Adds a part assembly (default).
DELETE - Deletes a part assembly.
- LIST - Lists each part assembly number, and the part numbers that make up each part
assembly.
- asmid
User defined part assembly ID number. The part assembly number cannot be the same as any currently defined part ID number.
- part1, part2, part3, … , part16
Part numbers to be included in the assembly (up to 16 different parts).
Notes
Several ANSYS LS-DYNA commands (such as EDCGEN, EDPVEL, and EDIS) refer to assembly ID numbers. If you intend to use assembly ID numbers with these commands, you must first define the assembly ID numbers using EDASMP.
Distributed ANSYS Restriction: This command is not supported in Distributed ANSYS.