dlist

Mapdl.dlist(node1='', node2='', ninc='', **kwargs)

Lists DOF constraints.

APDL Command: DLIST

Parameters:

node1, node2, ninc

List constraints for nodes NODE1 to NODE2 (defaults to NODE1) in steps of NINC (defaults to 1). If ALL (default), NODE2 and NINC are ignored and constraints for all selected nodes [NSEL] are listed. If NODE1 = P, graphical picking is enabled and all remaining command fields are ignored (valid only in the GUI). A component name may also be substituted for NODE1(NODE2 and NINC are ignored).

Returns:

str

Str object with the command console output. This object also has the extra methods: to_list(), to_array() (only on listing commands) and to_dataframe() (only if Pandas is installed).
NOTE: If you use these methods, you might obtain a lower precision than using Mesh methods.
For more information visit Postprocessing.

Notes

Listing applies to the selected nodes [NSEL] and the selected degree of freedom labels [DOFSEL].

This command is valid in any processor.