usrdof

Mapdl.usrdof(action='', dof1='', dof2='', dof3='', dof4='', dof5='', dof6='', dof7='', dof8='', dof9='', dof10='', **kwargs)

Specifies the degrees of freedom for the user-defined element USER300.

APDL Command: USRDOF

Parameters:

action

One of the following command operations:

DEFINE - Specify the degrees of freedom (DOFs). This value is the default.

LIST - List all previously specified DOFs.

DELETE - Delete all previously specified DOFs.

dof1, dof2, dof3, … , dof10

The list of DOFs.

Notes

The USRDOF command specifies the degrees of freedom for the user- defined element USER300.

Although you can intersperse other commands as necessary for your analysis, issue the USRDOF command as part of the following general sequence of commands:

Issue the ET command for element USER300, followed by the related TYPE command.

Issue both the USRELEM and USRDOF commands (in either order).

Define your element using USER300.

The DOF list (DOF1 through DOF10) can consist of up to 10 DOFs. Use any valid and appropriate DOF (such as UX, UY, UZ, ROTX, ROTY, ROTZ, AX, AY, AZ, VX, VY, VZ, PRES, WARP, TEMP, VOLT, MAG, EMF, and CURR).

You can specify a maximum of 10 DOFs per USRDOF command. To define additional DOFs, issue the command again.

The maximum number of DOFs for a user-defined element–the number of nodes times the number of DOFs per node–cannot exceed 480.

To learn more about user-defined elements, see Creating a New Element in the Programmer’s Reference.